[PATCH] Add Blackfin support in newlib (try 3) (was Re: [PATCH] Add Blackfin support in newlib (try 2))

[Jeff Johnston]

Ok, I just switched over to FC6 and I see what you are experiencing.  I 
am surprised at the lack of back-level compatibility with the autotools 
project, but I guess I will have to regenerate the files and check them 
back in, otherwise, everyone is going to soon run into this problem.

-- Jeff J.

Jie Zhang wrote:
> Sorry for the delay.
> 
> Jeff Johnston wrote:
>> Jie Zhang wrote:
>>> I found I need automake 1.9.5 to generate Makefile.in. Is it in plan 
>>> to update newlib to use automake 1.9.6?
>>>
>>
>> Eventually.  Are you seeing errors using automake 1.9.6?
>>
> What I saw was
> 
> src/newlib/libc/machine/bfin$ automake
> configure.in:11: version mismatch.  This is Automake 1.9.6,
> configure.in:11: but the definition used by this AM_INIT_AUTOMAKE
> configure.in:11: comes from Automake 1.9.5.  You should recreate
> configure.in:11: aclocal.m4 with aclocal and run automake again.
> jie@Jzhang3-L01:~/sources-cvs/newlib/src/newlib/libc/machine/bfin$ aclocal
> jie@Jzhang3-L01:~/sources-cvs/newlib/src/newlib/libc/machine/bfin$ automake
> configure.in:11: version mismatch.  This is Automake 1.9.6,
> configure.in:11: but the definition used by this AM_INIT_AUTOMAKE
> configure.in:11: comes from Automake 1.9.5.  You should recreate
> configure.in:11: aclocal.m4 with aclocal and run automake again.
> 
> 
> Thanks,
> Jie