[ECOS] how to add ethernet support for SNDS

Roland Caßebohm roland.cassebohm@visionsystems.de
Fri Feb 20 09:41:00 GMT 2004


On Freitag, 20. Februar 2004 10:34, Jonathan Larmour wrote:
> Roland Caßebohm wrote:
> > On Freitag, 20. Februar 2004 05:46, Jonathan Larmour wrote:
> >>However, just to be clear, do you know that someone still needs to port
> >> the KS32C5000 driver to the SNDS platform? There's a bit of glue
> >> required before it will work.
> >
> > As I know the ks32c5000 driver works as it is with the SNDS100 board.
> > To get a network ready RedBoot for SNDS100 you only have to add the
> > ks32c5000 ethernet package and the generic ethernet package.
> > As I can remember is the default phy device the right one, so it
> > should work.
>
> I stand corrected. Because it was shared between two platform ports I
> assumed it was going to require per-port customisation, but I forgot it was
> onchip and therefore would be the same (other than potentially the PHY as
> you say). Fair enough!
>
> In that case, I wonder why it isn't listed in ecos.db for the snds100
> target.

Yes, now I remember that I had always problems to add the package with
the configtool, because at the time when I used the SNDS100 board I
didn't known to add this to the target in ecos.db.

Roland

-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss



More information about the Ecos-discuss mailing list