CDF's in GSL

[Rajarshi Guha]

On Sat, 2003-08-30 at 12:23, Jason Hooper Stover wrote:
> On Fri, Aug 29, 2003 at 12:49:17PM -0400, Rajarshi Guha wrote:
> > Hello,
> >   I'm trying to to a chi square goodnes of fit on some of my data.
> > 
> > As far as I understand I need to use assume a distribution and calculate
> > the CDF. When I looked up the available CDF's I see that each
> > distribution provides two of them: P(X) & Q(x)
> > 
> > I'm a little confused as to which one I should be using. The manual
> > states that CDF's are clculated seperately for the upper and lower tails
> > - but how do I decide which CDF to use?
> 
> The usual way to run a goodness-of-fit test is to compute 
> pval = Pr(Xsq>t) = gsl_cdf_chisq_Q(t,nu), where t is the test statistic you 
> compute from your data and nu = degrees of freedom of t.
> Then reject the null hypothesis if pval < Pr(type 1 error).

Thanks for information. I had a related question and that is, is it
possible in GSL to calculate the above pval for a given significane
level? As I understand from  the above I would have to calculate my pval
as you described and then look up tables to compare to a pval for my
significance level. Is there a way I could calculate the pval for a
desired significance level?

Thanks,

-------------------------------------------------------------------
Rajarshi Guha <rajarshi@presidency.com> <http://jijo.cjb.net>
GPG Fingerprint: 0CCA 8EE2 2EEB 25E2 AB04 06F7 1BB9 E634 9B87 56EE
-------------------------------------------------------------------
There's no problem so bad that you can't add some guilt to it to make
it worse.
-Calvin