installing problem with blas in GSL

[Juha Toivonen]

Some data first:
________________________________________________________________


blas_raw_native.lo      source_ger.h            source_symv.h
blas_raw_native.o       source_gerc.h           source_syr.h
blas_raw_native_cm.c    source_geru.h           source_syr2.h
blas_raw_native_cm.lo   source_hbmv.h           source_tXsv_c.h
blas_raw_native_cm.o    source_her.h            source_tXsv_r.h
gsl_blas.h              source_her2.h           source_tbmv_c.h
gsl_blas_raw.h          source_hpmv.h           source_tbmv_r.h
gsl_blas_raw_L1.h       source_hpr.h            source_tbsv_c.h
gsl_blas_raw_L2.h       source_hpr2.h           source_tbsv_r.h
gsl_blas_raw_L3.h       source_iamax_c.h        source_tpmv_c.h
gsl_blas_raw_cm.h       source_iamax_r.h        source_tpmv_r.h
gsl_blas_types.h        source_nrm2_c.h         source_tpsv_c.h
gsl_cblas.h             source_nrm2_r.h         source_tpsv_r.h
matrix_access.h         source_rot.h            test_blas_raw.c
source_asum_c.h         source_rotg.h           test_cases.c
source_asum_r.h         source_rotm.h           test_cases.h
source_axpy_c.h         source_rotmg.h
unixplace27%%%: make check
/bin/sh ../libtool --mode=link gcc  -g -O2  -o libgslblasnative.la
-rpath ~/gslexec_2//lib  blas_raw_native.lo blas_raw_native_cm.lo  -lm
libtool: link: only absolute run-paths are allowed
*** Error code 1
make: Fatal error: Command failed for target `libgslblasnative.la'
unixplace28%%%: 
___________________________________________________________________

So the "make check" was run in ./... /gsl-0.6/blas 
after I had given the successful configure command 
"configure --prefix=~/gslexec_2" and the unsuccessfull
"make" command. I assume the problem is in the second 
line, in the part "~/gslexec_2//lib" because there are
too many /-symbols. First I thought that problem was
my bad configure command "configure --prefix=~/gslexec_2/"
but after that I gave the "configure --prefix=~/gslexec_2"
and it didnt make any difference. (I dont know if this is 
relevant, but I think it is not.)

So what will I do to go on successfully??
Thank you for your help,

Juha Toivonen
jumito@utu.fi
Turku University
Finland