strange problems using gdb for arm target

[Mangesh Edake]

Hello all,
   I'm posting once again as I havn't got any reply,
but this time will give some more details about same
two problems I have -
  
1) for each new gdb session, start - connect -
dissconnect - close Hyperteminal, then only gdb
connects to target, why this is so?

2)My host machine (running gdb) suddenly restarts...?
I am using prolific USB to Serial Bridge cable for
communication. USB end of that cable connects to host
and Serial end to target. Will this cable cause host
to restart...?

I am srongly facing these two problems at every gdb
session which are slowing down my main activity of
writing a stub.

So this time I'm greatly hoping for at least a single
reply from the list. Anyone, though don't have
solution for this, could at least suggest me what may
be the cause of any of the problems.... 
Is there Nobody...? I realy hope for somebody.

Thanks and Regards,
medake 



Note: forwarded message attached.


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
-------------- next part --------------
An embedded message was scrubbed...
From: Mangesh Edake <m_edake@yahoo.com>
Subject: problems debugging ARM target
Date: Wed, 17 May 2006 03:47:48 -0700 (PDT)
Size: 2217
URL: <http://sourceware.org/pipermail/gdb/attachments/20060524/e308767a/attachment.eml>