[ECOS] Can't connect to remote Evaluator 7T

[Jonathan Larmour]

Pierre Habraken wrote:
> Here is the contents of gdblog.txt :
> w +$Hc-1#09
> r <Timeout: 2 seconds>
[snip]

Oh, my mistake, you really are reading absolutely nothing from the target, 
rather than it being corruption.

> What is strange is that if I quit gdb and then launch kermit at once
> without resetting the board, then redboot is there responding to
> commands such as 'version'.

If it is, then it can't have received anything from GDB that told it to 
switch to GDB remote protocol mode. Otherwise you wouldn't be able to as 
it would be expecting GDB output.

> About the serial settings, I did not find any gdb command allowing to
> change anything but the baudrate. I know that the speed is correct
> (38400) but have no idea concerning the others parameters (parity,
> etc.).

Unfortunately GDB can't. I suggest you look at flow control and ensure 
that is off. Also make sure nothing else is accessing the serial port at 
the time. Try minicom instead of ckermit just in case.

Jifl
-- 
eCosCentric    http://www.eCosCentric.com/    The eCos and RedBoot experts
--[ "You can complain because roses have thorns, or you ]--
--[  can rejoice because thorns have roses." -Lincoln   ]-- Opinions==mine