H8300 - Addition of Pseudo registers has broken displaying of CCR and EXR registers

Dhananjay R. Deshpande dhananjayd@KPITCummins.com
Mon Dec 1 13:06:00 GMT 2003


Hi,

With the addition of Pseudo registers, "info reg" command doesn't show correct values of CCR and EXR registers. If you set these registers from GDB ( set $ccr = 0x55 )then it shows correct value but when the register is modified by instruction it always shows "0". This fails both with SIM and remote target ( stub )

Regards,
Dhananjay



More information about the Gdb mailing list