ARM TARGET

[Lavu Sridhar]

I have the file gdb 5.0 . I had to make changes in the gdb/makefile to
enable the target rdi debugging.

When I had done ./configure in the main directory, it was configuring gdb
for host i686 and target also i686, where as I want the target to be my
Cirrus Logic Arm 7500FE Baord. I do not know how to sepcify the exact
option for this arm processor. Currently the board has only the ANGEL
debugger program running.

I already have the vmlinux, and the zImage files for the Linxu kernel
2.3.99 . My host PC is RedHat 6.1 and i686 architecture.

I am using the gdb mainly for downloading the image files into the RAM on
my target baord from my Host PC.

I hope you could provide me with some suggestions.

Thanks
-Lavu Sridhar

On Fri, 26 May 2000, Fernando Nasser wrote:
>
>Lavu Sridhar wrote:
>> 
>> Thank you for the mail.
>> 
>> I have complied using the arm linux cross tool chain (binutils 2.9.5.0.22)
>> and have the vmlinux file.
>> 
>> Using the gdb 5.0, I want to load the image into the CL7500FE processor.
>> How do I configure the target as my 7500FE processor? Do i give the
>> option:
>> 
>> ./configure --target=arm-pc-linux-gnu
>> 
>> or some other option?
>> 
>You haven't mentioned Linux before so I assumed you had a board with a
>monitor or something (an embedded target).
>
>How did you configure your gdb after all (i.e., what was the configure
>command you used)?
>
>Have you run make install?  What is in your bin directory?
>