[PATCH] Enable count for breakpoints

[Stan Shebs]

On 2/10/12 10:29 AM, Tom Tromey wrote:
>>>>>> "Stan" == Stan Shebs<stanshebs@earthlink.net>  writes:
> Stan>  This patch implements a request from Ericsson GDB users, to generalize
> Stan>  "enable once" so that breakpoints can be disabled after a given number
> Stan>  of hits instead of the first one.
>
> I looked at the patch and it all looked fine to me.
>
> I wondered what happened if a user did 'enable once 500' and 'ignore
> 500' for the same breakpoint.  From reading the code, I think 'ignore'
> takes precedence (first the ignores are done, then the enable once is
> handled).  I think this should either be documented, or one setting
> should zero out the other.
>

Yes, ignore takes precedence.  Thinking through the permutations, I 
think the two counts should remain decoupled, otherwise the user ends up 
trying to second-guess GDB's arithmetic.  Looking at "info break" output 
though, it looks like I should fine-tune the wording (and tweak the 
manual) to make it clear that's what is going on.

Stan