[PATCH] edit documentation for TUI mode
Bob Wilson
bwilson@tensilica.com
Fri May 11 18:30:00 GMT 2007
Eli Zaretskii wrote:
> The last sentence begs a question: ``how''? We should either answer
> that right there, or have an xref to where the appropriate command is
> described.
Good point. I'm not entirely sure what to do here. It would be best to specify
it directly, with a cross-ref for additional info, but there appear to be a lot
of different ways of switching into TUI mode. Even the "C-x C-a" key binding,
which is the most straightforward and also works to switch back out of TUI mode,
has 3 different variations: "C-x C-a", "C-x a" and "C-x A".
What do you think about changing that sentence as follows?
You can also switch in and out of TUI mode while @value{GDBN} runs by using
various TUI commands and key bindings, such as @kbd{C-x C-a}. @xref{TUI Keys, ,
TUI Key Bindings}.
> Why did you switch to `@table @asis' and an explicit @key in each
> item? What was wrong with the previous method?
The last entry, "C-L", is not a key. It needs to be formatted with @kbd. The
difference doesn't matter much for Info output, but for TeX output, it is bad to
have a key-shaped box with "C-L" inside it.
--Bob
More information about the Gdb-patches
mailing list