[Bug 1001219] Ethernet driver for STM32 connectivity line with port on MMstm32f107 board.

[bugzilla-daemon@bugs.ecos.sourceware.org]

Please do not reply to this email, use the link below.

http://bugs.ecos.sourceware.org/show_bug.cgi?id=1001219

Jerzy Dyrda <jerzdy@gmail.com> changed:

           What    |Removed                     |Added
----------------------------------------------------------------------------
   Attachment #2036|0                           |1
        is obsolete|                            |

--- Comment #55 from Jerzy Dyrda <jerzdy@gmail.com> ---
Created attachment 2093
  --> http://bugs.ecos.sourceware.org/attachment.cgi?id=2093&action=edit
Eth driver for STM32 family.

Hello Ilija,

(In reply to comment #54)
> (In reply to comment #53)
> > Created attachment 2036 [details]
> > Eth driver for STM32 family.
> > 
> > Hello Ilija,
> > 
> > (In reply to comment #51)
> > > Created an attachment (id=2027) [details]
> > > TCP/IP checksum CDL fix 130115 (Incremental to attachment 2013 [details])
> > > 
> > > There is a bug in IP/TCP/UDP checksum generation/checking CDL. The attached
> > > patch should fix. Check if it works for your target.
> > Ups. Now should be better and I hope that it's last issue to fix.
> 
> There's more. Have you tested with hardware checksum enabled? It doesn't
> work on my target. Problem are the same macros, only in C source.
> 
> So check for other similar issues, than fix and than test, test and test.
> Until you are sure that it works with both hw and sw checksum.
> Then test again before you post the patch.
> And for the end, don't forget to test.
Yes. You are absolutely right but my wiling to test becomes lower and lower
during so long time.

I hope that we are finalizing release of driver.

Best regards,
jerzy

-- 
You are receiving this mail because:
You are on the CC list for the bug.