[Bug 1001219] Ethernet driver for STM32 connectivity line with port on MMstm32f107 board.

[bugzilla-daemon@bugs.ecos.sourceware.org]

Please do not reply to this email, use the link below.

http://bugs.ecos.sourceware.org/show_bug.cgi?id=1001219

--- Comment #61 from Ilija Kocho <ilijak@siva.com.mk> ---
(In reply to comment #60)
> Hello Ilija,
> 
> (In reply to comment #59)
> > I was about to commit but in the last check I noticed something that needs
> > explanation.
> > 
> > The function hal_stm32x0_led(). I assume there is some conflict with
> > ethernet. Please explain.
> > 
> > There must be better solution that deletting 3 leds.
> > 
> > 1. Make compilation conditional, so LEDS are in use when possible and
> > ommitted otherwise.
> > 
> > 2. Remove this function completely. or replace it with new. (I wouldn't
> > reccommend this).
> > 
> > If above assumption is not correct, there may be other solutions as well.
> Sorry I omitted it during checking. This was used by me only for my debug
> purpose. Development board, which I used, has only one LED. 
> Please skip this change it's absolutely not needed by driver.
> 

For avoidance of doubt: I revert the code for this function to the state before
adding of Ethernet driver.

Ilija

-- 
You are receiving this mail because:
You are on the CC list for the bug.