[Bug 1001219] Ethernet driver for STM32 connectivity line with port on MMstm32f107 board.

[bugzilla-daemon@bugs.ecos.sourceware.org]

Please do not reply to this email, use the link below.

http://bugs.ecos.sourceware.org/show_bug.cgi?id=1001219

--- Comment #60 from Jerzy Dyrda <jerzdy@gmail.com> ---
Hello Ilija,

(In reply to comment #59)
> I was about to commit but in the last check I noticed something that needs
> explanation.
> 
> The function hal_stm32x0_led(). I assume there is some conflict with
> ethernet. Please explain.
> 
> There must be better solution that deletting 3 leds.
> 
> 1. Make compilation conditional, so LEDS are in use when possible and
> ommitted otherwise.
> 
> 2. Remove this function completely. or replace it with new. (I wouldn't
> reccommend this).
> 
> If above assumption is not correct, there may be other solutions as well.
Sorry I omitted it during checking. This was used by me only for my debug
purpose. Development board, which I used, has only one LED. 
Please skip this change it's absolutely not needed by driver.

Best regards,
jerzy

-- 
You are receiving this mail because:
You are on the CC list for the bug.