MPC860: quicc_smc_serial_driver change

[nprasad3@gmu.edu]

Gary,

That was it!, disabling the I/O startup messages, the diag and interrupt serial driver co-exist. Output is the same as the last one except Init messages are not present.

Polling mode would help take care of the startup I/O messages also.

Thanks
Nirmal


----- Original Message -----
From: Gary Thomas <gary@mlbassoc.com>
Date: Thursday, January 8, 2004 12:43 pm
Subject: Re: MPC860: quicc_smc_serial_driver change

> On Thu, 2004-01-08 at 10:38, nprasad3@gmu.edu wrote:
> > Gary,
> > 
> > I am attaching the output from 3 different runs on my platform 
> of the same 
> > tester. I had used the mbx port as a starting point but looks 
> like the diag 
> > and interrupt driver do not like each other.
> 
> Can you try it *without* the I/O initialization messages turned 
> on?  
> I've seen troubles with that before.
> 
> -- 
> Gary Thomas <gary@mlbassoc.com>
> MLB Associates
> 
> 
>