[ECOS] RedBoot necessary for porting ecos?
Michael Jones
mjones@linear.com
Fri Jan 11 15:25:00 GMT 2013
Lukas,
Ilija is correct, I was in a hurry and did not see the word "port" in your request. Therefore, my recommendations assumed your platform was supported.
Mike
On Jan 11, 2013, at 12:55 AM, Ilija Kocho <ilijak@siva.com.mk> wrote:
> Hello Lukas
>
> Actually RedBoot works on top of eCos so before eCos is ported you can't
> run RedBoot.
>
> Porting eCos to Cortex-M is relatively straight-forward (compared to
> other architectures) because some essential components are
> implemented/defined on architectural level: interrupt controller,
> systick, and general memory map.
>
> In most cases, all you need to make in order get first eCos "Hello
> World!" on serial line are:
> 1. Clocking
> 2. Diagnostic (HAL) serial support.
>
> Once you have reached this point, you can start with device drivers
> (serial, Ethernet, etc).
>
> Regarding peripheral drivers: Before you start coding, do some research
> through eCos source tree, it is possible that your chip has some
> peripherals that are already supported for other architectures, then you
> can probably use the same drivers (with or without some tweaks). Usually
> the manufacturers combine same peripherals with different architectures.
> For instance LPC17xx uses drivers from LPC2xxx.
>
> Have fun!
> Ilija
>
> On 11.01.2013 01:55, Lukas Riezler wrote:
>> Hello everyone!
>>
>> First I have to say, that I'm quite new in microcontroller theme (and my english is not so good).
>> But I'm interested to get ecos run on my IAR-EvalBoard with CortexM3 (FM3).
>> I've read a lot of stuff but though I have some elementary questions:
>>
>> - is it a requirement to work with RedBoot or is it also possible to port ecos without using RedBoot?
>> - I know that RedBoot is based on the ecos-HAL. Does it mean, if I port RedBoot to my target, that I can use later the same HAL-Code for ecos?
>>
>> With kind regards,
>> Lukas R.
>>
>
>
> --
> Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
> and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
>
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
More information about the Ecos-discuss
mailing list