[ECOS] [ecos] AT91 SPI Problems (CS / SPI Modes)

Andrew Lunn andrew@lunn.ch
Mon Dec 13 15:31:00 GMT 2010


On Mon, Dec 13, 2010 at 04:10:46PM +0100, Ingo.Knuth@porsche-engineering.de wrote:
> Hello all,
> 
> We're having issues with ecos on two identical custom boards with an 
> AT91SAM7X-512 chip, similar to the AT91SAM7XEK Eval board. Additionaly, 
> there're MCP2515 CAN Controller and MCP23S08 PortExpander connected via 
> SPI (six devices at each SPI channel). 
> Actually it works; we can send and recevice data, we can use different 
> frequencies (1 to 10MHz) and the interrupts are working as well. But 
> because of the time critical application the following problem is serious.
> 
> The SPI ChipSelect is too long low for every instruction. 

The AT91 SPI driver is probably using the CS lines are GPIO pins. The
SPI core has a hardware bug where it changes the wrong CS line for
devices other than 0. So to get around this hardware bug the AT91 SPI
driver controls the CS lines itself. It might be worth reading the
errata and see if this has been fixed for the AT91SAM7X. I know it is
a problem for the AT91SAM7S. If it has been fixed you can modify the
SPI driver to allow the SPI core to control the CS lines.

    Andrew

-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss



More information about the Ecos-discuss mailing list