[ECOS]How to run testprograms for lwip

Robert Brusa bob.brusa@gmail.com
Fri Jul 24 15:51:00 GMT 2009


On Thu, 23 Jul 2009 14:27:59 +0200, Simon Kallweit  
<simon.kallweit@intefo.ch> wrote:

> Robert Brusa wrote:
>> yes, I see some messages on ser1. It appears every few seconds, but I  
>> get the impression there is no answer comming back. I also hooked my PC  
>> to the LAN with wireshark and there as well, I see nothing originating  
>> from my board.
>
> What are the messages?
>
>> tcpecho: When attempting to connect to my board (where tcpecho is  
>> running) with telnet 192.168.0.222 I get the message
>>  telnet: Unable to connect to remote host: No route to host
>
> I guess you configured the IP address statically on your board. Please  
> make sure that the board is in the same network. For example, if you use  
> 192.168.1.0/24 as your network, you won't be able to ping 192.168.0.222  
> unless you have defined some routing or a separate IP address in the  
> 192.168.0.0/24 network.
>
>> I have the feeling its a hardware problem. The LEDs on the switch I am  
>> connected to with this board also remain dark all the time.
>
> Well, I can't really help you with that. Also, it seems you are using  
> the current lwip port available in the CVS (or ecos 3.0). I have not  
> used that port, as it was rather dated, so I ported a newer lwip  
> version. You could try my port too, a snapshot is available:
>
> http://download.westlicht.ch/lwip-20090722.tar.gz
>
> Simon


Hi Simon
Thanks for the link. I have downloaded the file and will check it out when  
I return from vacations - which start in a few minutes :-)
   Robert

-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss



More information about the Ecos-discuss mailing list