[ECOS] Problem with GDB/insight debugging standalone interrupt driven code

[Miklos.Pflancer@dBResearch.co.uk]

HI

Target - ARM LPC2292 Embest development board running Redboot

I think I have a problem with gdb stubs in redboot.

I can load and run a  standalone application which uses interrupts 
into external ram  using gdb, however If I set breakpoints or try to 
single step the application stops and gdb becomes unresponsive. 

I can burn the same application into flash and load with Redboot and 
this works fine.

I was wondering if  there are options in the configtool which should 
be selected but are'nt. I am not familiar with many of these 
settings. 

Can anyone offer any advice on this matter

Best Regards

Miklos

Miklos Pflancer
Electronics Engineer

--------------------------------------------------
email : miklos@dbresearch.co.uk
--------------------------------------------------
dB Research Ltd
Concept House
Merton Road
Bootle
Liverpool L20 3BG
UK

Tel (+44)(0)151 330 0800
Fax (+44)(0)151 330 0808
--------------------------------------------------

-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss