[ECOS] Isr not being called with smsc9111

Sinan KAYA sinan.kaya@siemens.com
Fri Nov 24 12:12:00 GMT 2006



hello,
I have an interesting problem with ecos and smsc9111.
 
I have a custom board with smsc9111 controller on it and i'm trynig to
get it working. I set the base address and interrupt addresses correctly
by defining the following. When i do not interrupt systems boot up
sequence, i realized that isr function is not being called by setting a
breakpoint to it. However, if i do a stop from insight ide and then
continue i start to get the ping replies.  What could be the reason ? 
 
The output of the debug messages are shown below:
 
 
Intern>Network stack using 65536 bytes for misc space
                    65536 bytes for mbufs
                    131072 bytes for mbuf clusters
LAN91CXX - supposed BankReg @ 3240000e = 3300
LAN91CXX - type: 9, rev: 1
LAN91CXX - status: 0000
LAN91CXX - static ESA: 12:13:14:15:16:17
BOOTP[eth0] op: REPLY
       htype: Ethernet
        hlen: 6
        hops: 0
         xid: 0x0
        secs: 0
       flags: 0x0
       hw_addr: 12:13:14:15:16:17
     client IP: 192.168.1.200
         my IP: 192.168.1.200
     server IP: 192.168.1.202
    gateway IP: 192.168.1.201
  options:
        subnet mask: 255.255.255.0
       IP broadcast: 192.168.1.255
            gateway: 192.168.1.201

 
regards,
sinan.

--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss



More information about the Ecos-discuss mailing list