[ECOS] RedBoot Built but says No network interfaces found

[Madhava Reddy S]

Hi All,

I am new to ecos and want to test sample program on target i386 PC.

I have seleted i386 PC hardware template and packages as redboot.

In the configuration tool i have done the following things:
1.set up the configuration options for our RedBoot
build. 
2.select configuration options and verify them.
We set the IP Address and Serial port
configurations for RedBoot ROM
monitor.
3.Save the configuration .
4.Loaded the boot loader to Floppy Disk.
5.Booting the target Board.

When i boot the target system it is displaying following..

IDE failed to identify unit 0 -wrote: a0, read:16
IDE failed to identify unit 0 -wrote: b0, read:6 
IDE failed to identify unit 1 -wrote: a0, read:f 
IDE failed to identify unit 0 -wrote: b0, read:1
No network interfaces found.
...
...
...
RedBoot>

I have intel 82558 and Realtek Cards in the target systems

I have gone through intel 8255X_OpenSDM.pdf he says 
82559 is Backward compatible with 82558.

Can i use intel 82558 card.If i can use it where did i do wrong.

If anyone know about this please help me out.

Regards,
Madhava S

-------------- next part --------------
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message.Global Edge Software Ltd has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Global Edge Software Ltd reserves the right to monitor and review the content of all messages sent to or from this e-mail address

-------------- next part --------------
-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss