[ECOS] gdb:stepi/continue problem

[Ganeshan]

I'm running ecos on a hitachi h8300h 3064 board.
I boot up to redboot and connect to the serial port via
Gdb and load my ecos application image.

I could not able to stepi or continue after loading the image.
$ h8300-elf-gdb -nw a.out
(gdb) set remotebaud 38400
(gdb) target remote /dev/ttyS0
Remote debugging using /dev/ttyS0
0x000060f2 in ?? ()
(gdb) load
Loading section .text, size 0xfbaa lma 0x204000
Loading section .rodata, size 0x985 lma 0x213baa
Loading section .data, size 0x6e0 lma 0x214530
Loading section .int_hook_table, size 0x100 lma 0x214c10
Start address 0x204000, load size 68879
Transfer rate: 17219 bits/sec, 63 bytes/write.
(gdb) stepi


Nothing is displayed.  It is same for "continue" also.  What might be
the problem?

Thanks in advance

Ganeshan N



-------------- next part --------------
A non-text attachment was scrubbed...
Name: ganeshan.vcf
Type: text/x-vcard
Size: 349 bytes
Desc: Card for Ganeshan
URL: <http://sourceware.org/pipermail/ecos-discuss/attachments/20040106/0f48b212/attachment.vcf>
-------------- next part --------------
-- 
Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
and search the list archive: http://sources.redhat.com/ml/ecos-discuss