[ECOS] Interface initialisation for eth0
umesh jaiswal
umeshcj@yahoo.com
Fri Jun 28 12:05:00 GMT 2002
hi all ..
I am working on i386 pc .
I have configure the rtl8139 device driver(of ecos)
.It is working (probably)
but The problem may be with interface initialisation
.
I am initialising the interface with
CYGHWR_NET_DRIVER_ETH0_SETUP_OPTIONS
via init_all_network_interfaces() for 'eth0'
statically.
During startup it is showing all the values of
addresses setups for 'eth0'
but when i run the ping test it fails giving the
massage like host down & recvfrom time out.
whereas destination host is up & can be
ping from any other pc.When I debug the interface code
I found that the arp request packet has source &
destination IP address same ,i.e. of target itself .I
am unable to find it out why it is happening .please
help me where is the actual problem ?is it in inteface
initialisation or device driver code ?
Regards!!
umesh ,ensys
__________________________________________________
Do You Yahoo!?
Yahoo! - Official partner of 2002 FIFA World Cup
http://fifaworldcup.yahoo.com
--
Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
and search the list archive: http://sources.redhat.com/ml/ecos-discuss
More information about the Ecos-discuss
mailing list