[ECOS] AT91EB40 wiggler JTAG programmer

[Ulrich Dahl]

Hi

Yes I press C, and it writes Continueing

I press Ctrl-Z and start "minicom -o", press enter some times and
absolutely nothing happens..

But I think it is because I have tried out the Atmel example code and
flashed the rom with it... It might be confused, who knows..

I am trying to get the JTAG interface to erase the upper mem part of the
flash but it doesn't seem to work... But there is still a little hope..

Best regards
Ulrich

On Fri, 2002-08-09 at 16:24, Tim Drury wrote:
> Ulrich Dahl wrote:
> > Hi
> > 
> > I seem to recall that Scott had a problem on the EB40 board were he
> > could get redboot_RAM into ram but it seemed like it wouldn't execute
> > the redboot code, because he didn't get a prompt in minicom..
> > 
> > I have the exect same problem, angel will load redboot_RAM into ram but
> > not execute it..
> > 
> > So I wanted to use the JTAG interface to write redboot_ROMRAM straight
> > into Flash, and thus not needing to worry about Angel..
> > 
> > But I will try again, with xyzmodem, maube the problem is minicom..?
> > 
> 
> It's all coming back to me now....
> 
> You did remember to issue 'c' in gdb right?  That starts redboot
> running on the board.  Then you have to shell-out of gdb by doing
> a ctrl-z so it will release the serial port so minicom can use it.
> 
> Remember to start minicom using 'minicom -o'  to bypass any serial
> port initialization.  Be sure minicom is setup to use 8N1 @38400.
> Hit enter a couple times and the redboot prompt should appear.
> 
> Another EB40A issue I had was the clock speed.  That is all fixed
> in the patches I submitted.  Hopefully those will get applied to cvs
> soon.  The EB40 should be fine.
> 
> -tim
> 
> 
> 



-- 
Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
and search the list archive: http://sources.redhat.com/ml/ecos-discuss