[ECOS] XScale IQ80310 ethernet problem

[Richard Wicks]

I found the problem, it's the motherboard the XScale is plugged into or the 
power supply that powers the entire mess.

I've wasted two days on this. Anyhow, it's either the Antec power supply or 
the Intel D850GB MB at fault or possibly something even more exotic.  I think 
it's the power supply though.

Sorry to waste everybody else's time with this.

Thanks for the help Mark. If I experience similar problems I'll let you know. 
I also will probably have to build a redboot at some point in the next two 
months - if I do I'll share a copy of the binary with you.

Thanks, and sorry,
-Rich

On Monday 10 September 2001 02:00 pm, Mark Salter wrote:
> >>>>> Richard Wicks writes:
> >
> > You can see on the second line "No network interfaces found".  There is
> > no link LED upon startup, however:
> >
> > I can run the "diag" command and test the ethernet port (test 10) and
> > everything passes.
> >
> > It may be my board revision.  According to the diag menu (option 19), my
> > board is:
> >
> > ------------------------------------------------------
> > Board Revision = F
> > CPLD Revision = D
> > 80200 Revision ID = 0x69052000
> > 80312 Revision ID = 1
> > ------------------------------------------------------
> >
> > Has anybody been able to get the ethernet to work with redboot on the Rev
> > F board?  I'm stuck.
>
> I have ethernet working on my Rev F board:
>
>   Board Revision = F
>   CPLD Revision = A
>   80200 Revision ID = 0x69052001
>   80312 Revision ID = 1
>
> I have seen occasional unexplained lockups of the ethernet channel on this
> Rev F whereas I never saw that on Rev D or E.
>
> I'm not sure how well synced that prebuilt binary is with respect to
> sources, so you might want to try building it yourself.
>
> --Mark