[ECOS] PC Card Interrupts

[Trenton D. Adams]

I have the following for my wavelan driver. 
ETH_DRV_SC(wvlan_sc,
           &_wvlan_priv_data, // Driver specific data
           "eth0",   // Name for this interface
           wvlan_start,
           wvlan_stop,
           wvlan_control,
           wvlan_can_send,
           wvlan_send,
           wvlan_recv,
           wvlan_int, // deliver function, called from fast net thread
           wvlan_int,
           wvlan_int_vector
    );

Is the following really sufficient for receiving an interrupt for a card
driver?
    cf_register_handler(dp->slot, (void*)eth_drv_dsr, sc);

Should something be added to the core PCMCIA interface such as card
PCMCIA controller interrupt handling as described below? Take for
instance the CL-PS6700 controller.  It has an interrupt that indicates
there's an interrupt on the card.  We could do something like the
following.


// Add this
struct cf_card_handler
{
	void (*handler)(void *);
	void *param;
}

// cf_slot updated to this.
struct cf_slot 
{
    int            index;       // In case hardware layer needs it
    int            state;
    unsigned char *attr;
    int            attr_length;
    unsigned char *io;
    int            io_length;
    unsigned char *mem;
    int            mem_length;
    int            int_num;    // Hardware interrupt number
    struct cf_irq_handler irq_handler;
    struct cf_card_handler card_handler;
};

// Add this
void cf_register_card_handler (struct cf_slot *slot, void
(*handler)(void *), void * param) 
{
	slot->card_handler.handler = handler;
	slot->card_handler.param = param;
}

I think it would be very beneficial because then the PCMCIA controller
driver could handle any interrupt clearing and things.  The card_handler
routine would only be called from the PCMCIA controller when an actual
card interrupt has occurred rather than calling it every interrupt like
irq_handler is. Maybe I'm just changing what was originally intended for
irq_handler?

We could still use the irq_handler routine to implement extra things
outside of the PCMCIA driver such as power management or something.


As it is right now, I have no way of know whether it's a card interrupt
or not unless I do the following.

// Inside wvlan_int ()
#ifdef __EDB7211    // Any other boards with a CL-PS6700?
    if (*(unsigned volatile*)PCISR & EV_PCM_RDY_L))
    {   // CARD INTERRUPT
#endif
// handle the card interrupt
#ifdef __EDB7211
    }
#endif

Either that, or have the PCMCIA controller driver only call the
irq_handler when it is a card interrupt.  That would however prevent me
from doing anything like power management when the controller is IDLE,
or the battery is low, etc.

What do you people think?