[ECOS] Changing memory layout

Daniel.Andersson@combitechsystems.com Daniel.Andersson@combitechsystems.com
Wed Nov 14 01:47:00 GMT 2001


I have a MPC850 board from TQC that i want to run eCos on. However, i do
need to change a few parameters since i intend to use the Viper board
(MPC860) as base.

The first thing i want to do is change the memory layout. Where do i do

I don't think its enough changing just the memory view in eCos config tool
since i also need to setup all chip select and so. Where shall i start?
Viper.S ?

Regards, Daniel

More information about the Ecos-discuss mailing list