[ECOS] not able to connect to gdb with redboot
Jonathan Larmour
jlarmour@redhat.com
Wed Jun 27 09:54:00 GMT 2001
Rajeev murthy wrote:
>
> dear Gary,
> i tried out the commands you have stated , but once i say tar remote /dev/ttyS0 the gdb hangs, never to come back. what must be the problem?
> i then connected the gdb to a hyperterm to see what it was sending , but it would send nothing. is there any changes required in gdb to be used with redboot?
Just in case there is some problem with Insight, you could try using the
command line at least temporarily (run gdb with "-nw"). Have you chosen the
correct baud rate? For example if it is 38400, do this with "set remotebaud
38400" before the "target remote".
Jifl
--
Red Hat, Rustat House, Clifton Road, Cambridge, UK. Tel: +44 (1223) 271062
Maybe this world is another planet's Hell -Aldous Huxley || Opinions==mine
Come to the Red Hat TechWorld open source conference in Brussels!
Keynotes, techie talks and exhibitions http://www.redhat-techworld.com/
More information about the Ecos-discuss
mailing list