[ECOS] Enable EDB7xxx interrupts

[Lewin A.R.W. Edwards]

>I tested the lines with a multi tester.  All the relevant lines

You might not see a pulse on that though.

Try clipping a lead on gnd or +3.3V (whichever edge trips your particular 
interrupt), and manually firing the interrupt by tapping the other end of 
the lead to the trace.

>sure yet.  I would think that if the controller is fully active like it
>appears to be then there would be no need to do something to enable the
>actual output of the interrupt lines, would there?  I mean the

probably an interrupt enable masking register in the controller, I haven't 
programmed that part but I'm using a couple of other PCMCIA interface parts 
that both have internal mask-off for interrupts.



-- Lewin A.R.W. Edwards
Embedded Engineer, Digi-Frame Inc.
Work: http://www.digi-frame.com/
Tel (914) 937-4090 9am-6:30pm M-F ET
Personal: http://www.larwe.com/ http://www.zws.com/

"Far better it is to dare mighty things, to win glorious triumphs, even 
though checkered by failure, than to rank with those poor spirits who 
neither enjoy much nor suffer much, because they live in the gray twilight 
that knows not victory nor defeat."
(Theodore Roosevelt)