[ECOS] redboot commands for install nanoxdemo on ipaq

[Jesper Skov]

>>>>> "Weilong" == Weilong Li <weilongli2000@yahoo.com> writes:

Weilong> In the last step to install nanoxdemo permanently on ipaq,

Weilong> after I typed

Weilong> fi cr RedBoot[backup] -b 0x20000 -r 0x20000 -e 0x20040

Weilong> I got error message like: the required parameter is
Weilong> missing. And the usage message of fis.

Weilong> Anyone know the problem?

Yes, you didn't specify -l   - RedBoot doesn't know how much data to
write.

Maybe you didn't run 'fi init' That would usually take care of things
and make the above line valid - **** but only do this if it's in the
instructions ****. I don't know if it may risk bricking the board.

Bottom line is, go over the instructions very carefully and make sure
you follow them to the letter!

Jesper