[ECOS] JEENI with ecos

[Daniel Néri]

rob.wj.jansen@philips.com writes:

> Only problems arise on the GDB side, where GDB may crash on
> connecting (in this case the Jeeni needs a reset) or where GDB may
> just hang (mainly because the target has gone through a reset after
> connecting).

In my experience, this happens a lot with the ARM debugger too[*].

Regards,
   --Daniel

[*] Using ARM SDT v2.50 and JEENI firmware rev2.0.

-- 
Daniel Neri                                      mailto:dn@sigicom.com
Sigicom AB, Sweden                              http://www.sigicom.com