[ECOS] GDB stubs on EDB7211

[Olaf Peters]

Lewin,

Thanks for your help so far.

> >an eCos snapshot from 26 januari 2001 and created the edb7xxx
> gdbrom stubs.
> >Than I programmed the gdb_module.bin file into the EDB7211 flash.
>
> You might find it easier, as I did, to start with the "official
> release" of
> eCos, 1.3.1 rather than a snapshot. The 1.3.1 release comes with a
> pre-compiled binary ready to flash.

The pre-compiled binary seems to work fine on my EDB7211 board.
But now comes the real problem: I have an EDB7211 alike
custom board, build around the EP7211 (flash, ram and ethernet controller
are the same). For this board I need to do some
additional hardware initialisations at start-up, so I need to be able to
compile
the EDB7211 GDB rom stub.
I tried to built the EDB7211 gdb stubs with eCos 1.3.1, but it
doesn't work (I followed the guidelines in the ecos-tutorial-arm.pdf file).
Any suggestions why the EDB7211 GDB stubs I built myself with eCos 1.3.1
don't work and the shipped images do work?

Tia,
Olaf.