[ECOS] gdb 'next' problem with i386 HAL

[John Gumb]

Hi,

I've managed to get the i386 HAL up and running without too much bother - the only oddity I have is with GDB. The 'step' command works fine but the 'next' command simply results in the program continuing without breaking at the next line.

I have seen some posts related to this in that the gdb front end translates 'next' into a setting of a temporary breakpoint and then issuing a 'continue' so I could imagine I might see this sort of behaviour.

After poking around a bit, I can't see anything obvious.

Any suggestions as to what's up would be appreciated.

Cheers,

John