[ECOS] Re: DHCP shuts down Ethernet device?

[Anthony Massa]

I am running RedBoot on an MBX board and downloading my eCos application
with networking support.

I noticed your post about the Ethernet device shutdown and was wondering if
I could possibly be running
into the same problem.  After I download my application over the Remote/TCP
GDB connection the application
runs, prints out a network stack usage message, outputs [New thread 1] and
then hangs before it gets into
my cyg_user_start routine.  The target disconnects from the debugger as
well.

Is this what you are seeing?

Does it sound like a similar problem to yours?

I can run my code over the serial port - and it does get into my
cyg_user_start routine.

--Anthony