[ECOS] cannot run test on PC

[Jonathan Larmour]

> "adon@walkersun" wrote:
> 
>     I have build all the files which eCos wanted, and I use the eCos to
> build the stubs for PC target follows the starting guild.
>     So, for the gdb_module.bin, I could make it into floppy and boot a
> PC, and I could let it communicated with host PC(I used the win2000 for
> the host). and then I open the "run test" in eCos configure tools, but I
> cannot get any further response form my target PC(pentiun II, 266M, 128M
> RAM). the target always hangup or reboot after download the test program,
> and I do not know the program either been download finished. So, could
> anybody guide me how to solve this???

Did you change your template back to "default" from "stubs" and rebuild all
the tests, preferably in a new build tree?

> And I also found another problem, when I configure the serial port speed
> to 115200 as default, and I let the target PC boot, but I found the
> target PC serial port speed also 38400, where am I wrong???

Nothing - this is again one of the failings of the i386-pc port I'm afraid.

Jifl
-- 
Red Hat, 35 Cambridge Place, Cambridge, UK. CB2 1NS  Tel: +44 (1223) 728762
"Plan to be spontaneous tomorrow."  ||  These opinions are all my own fault