[ECOS] Connecting gdb to AEB

[Andreas.Karlsson@combitechsystems.com]

Hi!

While following the "Getting Started with eCos" you shall connect to the
board using these gdb commands. 

(gdb) set remotebaud 38400 
(gdb) set mips-force-32bit-saved-gpregs 
(gdb) target remote COM1


This set mips.. command, should I replace it?
Entering the command I get:
(gdb) set mips-force-32bit-saved-gpregs
Error: No symbol table is loaded.  Use the "file" command.

/Andreas