[ECOS] Port to uCsimm (uC68EZ328)?

[Paul Beskeen]

> I am using it for a robot controller, but I'm coming to the realization
> that Linux is just too big for what I want to do.  It's hard to get
> good timing for motor control, etc, from it when running Linux.  So
> I'm going to take a whack at porting eCos to it, but before I get too
> far I wanted to see if anyone else is working on any ports to it,
> or at least any 68k ports.

To the best of my knowledge nobody is working on a 68k port at this time. If
you have any problems, please mail the list.

Paul.