[ECOS] BreakPoint problems !!

[P.Mahendra Babu]

Hello Everybody,
	
	We have downloaded ecos-SW tools for Linux and
	installed the tools for target powerpc-eabi.
	We use MBX860 board and have successfully fused
	stubrom for startup.
	Now, when we make programs, we are successfully
	able to download and run them. We are able to
	set more than one breakpoints but, only the
	first one is hit. After the first breakpoint is
	hit, there is no control... i.e., it doesn't stop
	in further breakpoints. Even step, next commands
	do not seem to work. Program just continues until
	exit point irrespective of the command given(step,
	next or continue..) What is the problem ?
	Does anybody else have the same problem ? Or the
	gdb stubs can handle only one breakpoint now ?
	When I list the breakpoints using "maintenance
	info breakpoints", all breakpoints are alive even
	after the first breakpoint is hit.
	Hope to receive a solution faaaaaaaaast.

thanx in advance,
Babu

                                            \\\|///
                                          \\  _ _  //
                                           (  @ @  )
¤----------------------------------------oOOo-(_)-oOOo----------------¤
¤ Mahendra Babu P. ,			                              ¤
¤ Research Engineer,                Phone :  +91-080-5510086          ¤
¤ C-DOT,			    Fax   :  +91-080-2263256          ¤
¤ Sneha Complex,		    Email :  babu@cdotb.ernet.in      ¤
¤ 71/1, Millers Road,		             pmbabu@yahoo.com         ¤
¤ Bangalore - 560 052, India.	    URL   :  http://i.am/pmbabu       ¤
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~