[ECOS] A build problem for ecos toolchain on Win2000
Ling Su
lingsu@palmmicro.com
Mon Aug 28 16:49:00 GMT 2000
Hi,
ÃÂ
I am not sure if it is a valuable question here, but I did meet this
problem a lot of times on Win2000 platform when IÃÂ was tring to build a
toolchain for mips64vr4300-elf target. Previously I have working version
toolchain on winNT platform.
ÃÂ
ÃÂ
The brief log message is as following, I use the same snapshot as when I
use in WinNT platform actually, but I failed to build it on win2000, is that a
common problem?
ÃÂ
Thanks!
ÃÂ
-Ling
ÃÂ
===================================
rm -f include/limits.h cp xlimits.h
include/limits.h chmod a+r include/limits.h rm -f include/float.h if [
xfloat-i64.h != xMakefile.in ]; then \ ÃÂ cp
../../../src/egcs-20000313/gcc/config/float-i64.h include/float.h &&
\ ÃÂ chmod a+r include/float.h; \ else :; fi rm -f
include/README cp ../../../src/egcs-20000313/gcc/README-fixinc
include/README chmod a+r include/README touch stmp-int-hdrs if [ -f
libgcc2.ready ] ; then \ ÃÂ ÃÂ ÃÂ ÃÂ ÃÂ ÃÂ ÃÂ true;
\ else \ ÃÂ ÃÂ ÃÂ ÃÂ ÃÂ ÃÂ ÃÂ touch libgcc2.ready;
\ fi echo '#define FLOAT' > fp-bit.c echo '#ifdef __MIPSEL__'
>> fp-bit.c echo '#define FLOAT_BIT_ORDER_MISMATCH' >>
fp-bit.c echo '#endif' >> fp-bit.c echo '#define US_SOFTWARE_GOFAST'
>> fp-bit.c cat ../../../src/egcs-20000313/gcc/config/fp-bit.c >>
fp-bit.c echo '#ifdef __MIPSEL__' > dp-bit.c echo '#define
FLOAT_BIT_ORDER_MISMATCH' >> dp-bit.c echo '#endif' >>
dp-bit.c echo '#define US_SOFTWARE_GOFAST' >> dp-bit.c cat
../../../src/egcs-20000313/gcc/config/fp-bit.c >> dp-bit.c make[1]: ***
No rule to make target
`../../../src/egcs-20000313/gcc/config/mips/ mips16.S', needed by
`stmp-multilib'.ÃÂ Stop. make[1]: Leaving directory
`/cygdrive/c/tmp/build/gcc/gcc' make: *** [all-gcc] Error 2 make: Leaving
directory `/cygdrive/c/tmp/build/gcc' ================================================
ÃÂ
ÃÂ
ÃÂ
More information about the Ecos-discuss
mailing list