[ECOS] Problem with PowerPC simulator
Andrew Lunn
lunn@ma.tech.ascom.ch
Wed May 5 03:26:00 GMT 1999
> Andrew> The changes i made to the configuration are to change the HAL
> Andrew> to PowerPC, and enable the Minimal simulator. The processor is
> Andrew> spinning outside of the program....
> These addresses are wrong. _start should be at 0x4000 or so. Are you
> sure you selected RAM startup, and didn't save and/or build on top of
> an different configuration?
You cannot set it to RAM/ROM startup. Then you select the Minimal
simulator the Startup type option is not available. Thats only for the
Cogent PowerPC Evaluation board. Do i have an old version of the
config tool? I have version 1.1, Oct 29, 1998, 04:59:55 (someone was
buring the midnight oil!)
Andrew
More information about the Ecos-discuss
mailing list