Updated: cygwin-1.5.22-1

Larry Hall (Cygwin) reply-to-list-only-lh@cygwin.com
Mon Nov 20 21:29:00 GMT 2006


towo@computer.org wrote:
> After recent updates (including cygwin1.dll, bash), starting an rxvt 
> showed the following message:
> 
> : command not found
> : command not found
> : command not found
> : command not found
> : command not found
> ': not a valid identifier
> : command not found
> ': not a valid identifier
> : command not found
> ': not a valid identifier
> : command not found
> ': not a valid identifier
> : command not found
> : command not found
> bash: /etc/profile: line 63: syntax error near unexpected token `done'
> 'ash: /etc/profile: line 63: `  done <<- EOF
> 
> So I looked into /etc/profile and it turned out to have DOS line-ends!


You must have had a '/etc/profile' that you edited to contain DOS line
endings.  Perhaps you switched from DOS to UNIX mounts during this
upgrade?  In any case, the change you made is correct.


> After fixing this manually, rxvt would start normally, except - 
> I suddenly had a US keyboard layout! (On a German keyboard.)


Perhaps this is caused by DOS line endings in other config files you
have?



-- 
Larry Hall                              http://www.rfk.com
RFK Partners, Inc.                      (508) 893-9779 - RFK Office
216 Dalton Rd.                          (508) 893-9889 - FAX
Holliston, MA 01746

--
Unsubscribe info:      http://cygwin.com/ml/#unsubscribe-simple
Problem reports:       http://cygwin.com/problems.html
Documentation:         http://cygwin.com/docs.html
FAQ:                   http://cygwin.com/faq/



More information about the Cygwin mailing list