problem while connecting GDB to an ARM board

[Larry Hall]

At 10:43 AM 8/4/2005, you wrote:
>I used to use linux to compile code for my ARM based board but I needed windows and cygwin 1.5.8 to connect to the platform and debug via the ARM Multi-ICE Server and the Multi-ICE gdb Server.
>I now have to stop using linux so, I installed the GNUARM Tool Chain for Cygwin. That Tool Chain needs 1.5.18 version of cygwin1.dll to work because it needs the _impure_ptr procedure.


_impure_ptr has been a part of Cygwin symbols for a long time now.  This is 
not new with 1.5.18.  Perhaps you meant some specific element referenced 
through _impure_ptr?  In any case, 1.5.18 is the version this list 
recommends you run with when using Cygwin.


>I thaught it was right but I can not connect to the platform anymore and get "putpkt: write failed: Software caused connection abort" error on trying to connect.


This is really a better question for the GNUARM folks.  I'm not sure there
are allot of GNUARM Tool Chain users subscribed to this list.


--
Larry Hall                              http://www.rfk.com
RFK Partners, Inc.                      (508) 893-9779 - RFK Office
838 Washington Street                   (508) 893-9889 - FAX
Holliston, MA 01746                     


--
Unsubscribe info:      http://cygwin.com/ml/#unsubscribe-simple
Problem reports:       http://cygwin.com/problems.html
Documentation:         http://cygwin.com/docs.html
FAQ:                   http://cygwin.com/faq/