Tool-chain build curiosity
Bill Gatliff
bgat@billgatliff.com
Thu Jul 3 15:53:00 GMT 2003
Shaun:
Where are you getting header files from?
b.g.
Shaun Jackman wrote:
>Hello all. I have a tricky puzzle for you. If you can figure this out,
>you have proven infinite knowledge of the GNU tool-chain, and will be
>immediately promoted to "Guru" if you have yet to attain that status.
>
>I have a version of the GNU tool-chain (binutils, gcc, newlib) patched
>to support WindowsCE. I have a source and binary distribution. I've been
>using the binary distribution so far, but would like to be able to
>compile it from source. So, here's the trick. If I use the following
>recipe:
> install the binary distribution
> make binutils
> make gcc
> make newlib
> install binutils
> install gcc
> install newlib
>The resulting tool-chain works fine. If however I do the following:
> start with a clean slate
> make binutils
> install binutils
> make gcc
> install gcc
> make newlib
> install newlib
>My tool-chain does not work. It compiles cleanly, and compiles
>executables for the target cleanly, but the executables do not run on
>the target (they crash). Any idea how starting with the known-good
>binary distribution allows me to build a working tool-chain?
>
>Thanks,
>Shaun
>
>
>
>------
>Want more information? See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
>Want to unsubscribe? Send a note to crossgcc-unsubscribe@sources.redhat.com
>
>
>
--
Bill Gatliff
Embedded GNU and Linux development, training
bgat@billgatliff.com
------
Want more information? See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sources.redhat.com
More information about the crossgcc
mailing list