Building binutils for PowerPC

Daniel.Andersson@combitechsystems.com Daniel.Andersson@combitechsystems.com
Sun Oct 14 16:39:00 GMT 2001


Hi again,

Thanks for your answer, you got me going on the right way. The problem was
that binutils had a relation to libiberty.a but the make script didn't
compile libiberty before binutils which of course had the effect the it
couldn't find libiberty.a. I had to issue "make all" separatly inside the
libiberty and also inside intl.

I've compiled binutils now and going straight for gcc, gdb and
insight....Wish me luck...:)

Regards, Daniel

> -----Original Message-----
> From: David Korn [mailto:dkorn@pixelpower.com]
> Sent: den 19 november 2001 19:09
> To: Andersson Daniel; crossgcc@sources.redhat.com
> Subject: RE: Building binutils for PowerPC
> 
> 
> >-----Original Message-----
> >From: Daniel.Andersson@combitechsystems.com
> >[mailto:Daniel.Andersson@combitechsystems.com]
> >Sent: 19 November 2001 18:00
> 
> >
> >Hi again,
> >
> >Well, i think the configure goes fine - see the below result.
> >
> >Any hints?
> 
> 
>   Well, it isn't obvious I agree.  The reason I asked is 
> because usually
> when I've seen this sort of error before
> 
> >> >/src/binutils-2.10.1/binutils/filemode.c
> >> >make[2]: *** No rule to make target 
> >> >`../libiberty/libiberty.a', needed by
> >> >`size.exe'.  Stop.
> 
> it is because the configure failed and so did not generate 
> the makefile
> for the file in question.  So my next questions are: is there anything
> obviously wrong with the libiberty/makefile ?  Or did 
> anything go wrong
> while it was building libiberty.a ?  I assume that there is no file at
> ../libiberty/libiberty.a ?
> 
>   And one more question:
> 
> >Configuring libiberty...
>      [snip]
> >xhost-mkfrag is unchanged
> 
>   Did you re-run the configure command to get that output?  
> Just checking.
> 
>       DaveK
> -- 
> Burn your ID card!  http://www.optional-identity.org.uk/
> Help support the campaign, copy this into your .sig!
> 
> 
> **********************************************************************
> This email and any files transmitted with it are confidential and
> intended solely for the use of the individual or entity to whom they
> are addressed. If you have received this email in error please notify
> the system manager.
> 
> This footnote also confirms that this email message has been swept by
> MIMEsweeper for the presence of computer viruses.
> 
> www.mimesweeper.com
> **********************************************************************
> 
> ------
> Want more information?  See the CrossGCC FAQ, 
> http://www.objsw.com/CrossGCC/
> Want to unsubscribe? Send a note to 
> crossgcc-unsubscribe@sourceware.cygnus.com
> 

------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com



More information about the crossgcc mailing list