Automated arm-linux-gcc and powerpc-linux-gcc build script

[bgat@open-widgets.com]

Where are you getting include/linux/autoconf.h from? It isn't created
if I strictly follow your procedure below...

b.g.

On Sun, May 06, 2001 at 01:06:09PM -0500, Joe deBlaquiere wrote:
> My solution to this has always been to specify ARCH,PROCESSOR, and 
> INCDIR. Here's the StrongARM version...
> 
>      (cd $sysroot_stage1/usr ; \
>       $MAKE -I$kernel_src ARCH=arm PROCESSOR=armv INCDIR=sa1100 
> TOPDIR=`pwd` symlinks include/linux/version.h)
> 
> What somebody really needs to do is determine how generic something like 
> this is. My initial guess is that the compiler is probably accepable for 
> any armv system. Any reason to suspect otherwise?
> 
> --
> Joe
> 
> bgat@open-widgets.com wrote:
> 
> > Phil:
> > 
> > 
> > I had assumed that, but it turns out that there are two symlinks in
> > the asm-arm subdir that get set to architecture-specific and
> > platform-specific subdirs.  I couldn't find another way to set the
> > symlinks, and the includes used during the glibc build don't seem to
> > work without them.
> > 
> > All I'm after is a way to set the symlinks to *something*.  Menuconfig
> > was a quick-and-dirty.
> > 
> > b.g.
> > 
> > 
> > On Fri, Apr 27, 2001 at 09:30:13PM +0100, Philip Blundell wrote:
> > 
> >>> On my way to an updated crossgcc faq, I have produced a script that
> >>> automatically builds an arm-linux or powerpc-linux toolchain FROM
> >>> SCRATCH, *without* using newlib headers anywhere.
> >> 
> >> It's probably not necessary to actually run menuconfig for ARM.  I think you 
> >> can get away with running `make oldconfig' and redirecting input from 
> >> /dev/null.  Nothing in the toolchain build process that I can think of cares 
> >> about the kernel configuration, and indeed the binaries that you end up with 
> >> will run on any subarchitecture.
> >> 
> >> p.
> >> 
> >> 
> >> 
> >> ------
> >> Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
> >> Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com
> >> 
> 
> 
> -- 
> Joe deBlaquiere
> Red Hat, Inc.
> 307 Wynn Drive
> Huntsville AL, 35805
> voice : (256)-704-9200
> fax   : (256)-837-3839
> 

-- 
Bill Gatliff
bgat@open-widgets.com

------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com