Error building sh-hms on Windows

[John Lowen]

I had the same problem with trying to build sh-hms for Linux and for Windows using CYGWIN. I saw a few messages related to this and there is a problem with it but I don't remember what it was. My solution was to build for sh-elf and this built ok. Since I was using gdb/Insight which understands ELF, it was no problem. If you can use ELF, I would recommend trying to build sh-elf.
John

AMT-Datasouth
jlowen@amtdatasouth.com
http://www.datasouth.com
(704)523-8500 ext. 132



>>> "Arati D" <aratid@kpit.com> 07/02 8:10 AM >>>
Hello,

I am building the GCC for sh-hms target on win NT using cygwin.

I am following the instructions in
http://sources.redhat.com/ml/crossgcc/2000-q2/msg00195.html .

I have successfully built and installed the binutils2.11.

I get the following error during 'make' of gcc-2.95.3

_muldi3
/cygdrive/c/TEMP/cc2LBMKA.s: Assembler messages:
/cygdrive/c/TEMP/cc2LBMKA.s:1: Fatal error: dwarf2 is not supported for this
obj
ect file format
make[3]: *** [libgcc2.a] Error 1
make[3]: Leaving directory `/home/kpit/sh-gcc/gcc'
make[2]: *** [stmp-multilib-sub] Error 2
make[2]: Leaving directory `/home/kpit/sh-gcc/gcc'
make[1]: *** [stmp-multilib] Error 1
make[1]: Leaving directory `/home/kpit/sh-gcc/gcc'
make: *** [all-gcc] Error 2


Any info on how to proceed would be helpful.


Regards,
Arati



------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com