Long Long Support for m68K targets
David Williams
davidwilliams@ozemail.com.au
Tue Aug 29 20:53:00 GMT 2000
Thanks for the pointer. Only two problems - where is configure.texi and
how do I read
it. I am running cygwin environment and so not all UNIX tools work there
(although a lot
do). I have been using GCC for a couple of years (pre-built binaries of
course) and I
have used a limited amount of UNIX tools/programs during that time.
Dave.
Michael Sokolov wrote:
> If you haven't already, read configure.texi. I have found it very good.
>
------
Want more information? See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com
More information about the crossgcc
mailing list