ICD BDM, gdb, and error 613 on 68331
Aaron J. Grier
aaron@frye.com
Thu Nov 11 13:54:00 GMT 1999
On Thu, Nov 11, 1999 at 04:38:33PM -0500, Quality Quorum wrote:
> I am using it. I have heavily modified original Gunter Magin's
> patches. I am using gdb 4.17 to control 68360. I can dig my patches
> if necessary, however, I suspect it may be something else:
This would be very useful...
> It is quite possible that your stuff is actually working fine and the
> problem is that you did not initialize all necessary (and there are a
> lot of them)peripheral registers corectly.
Ay, here lies the rub. I can't even touch the peripheral registers out
of a cold boot -- as soon as I touch them, I get stuck in the "error
613" loop. Performing the exact same initialization sequence under
ICD32 under DOS works just fine.
--
Aaron J. Grier | Frye Electronics, Tigard, OR | aaron@frye.com
"The simplistic anthropomorphism which asserts that source code has a
life separate from its creator or maintainer is the product of one
too many viewings of Tron." -- paraphrasing of anonymous post on /.
------
Want more information? See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com
More information about the crossgcc
mailing list