Accessing Wiggler from Linux GDB
Hans - Dulimarta
dulimart@egr.msu.edu
Tue Dec 21 07:16:00 GMT 1999
I'd like to know whether anyone could share his/her success story
accessing Macraigor's wiggler from GDM running on Linux. I have tried the
following two methods without any good luck:
1. From gdb 4.18 by running "target ocd /dev/lp0; target ocd wiggler
/dev/lp0". The debugger seemed to hang after printing the message
"Remote target wiggler connected to /dev/lp0"
2. From Linux BDM-driver patched gdb mentioned in the Cross GCC FAQ.
After running "target bdm /dev/bdm0" a kernel message
"Device or resource busy" was displayed.
Also, I'd like to hear from you who successfully accessed the Wiggler from
Cygwin GDB running on Win95/98 (not WinNT).
Thanks a lot.
--
Hans Dulimarta, Ph.D. dulimart@[egr.msu.edu, computer.org]
http://www.egr.msu.edu/~dulimart
Visiting Research Associate, Electrical & Computer Engineering
Michigan State University, East Lansing, MI 48824, (517) 432-7589
------
Want more information? See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com
More information about the crossgcc
mailing list