Set section vma for COFF in BFD gas [take 2]

Mark E. snowball3@bigfoot.com
Wed Jun 28 09:31:00 GMT 2000


This version makes the set_section_vma code DJGPP specific and adds a comment that 
other COFF targets that desire to work under BFD gas should execute that segment of 
code too.

GAS Changelog:

2000-06-27 Mark Elbrecht <snowball3@bigfoot.com>

	* write.c [BFD_ASSEMBLER && OBJ_COFF && TE_GO32] (set_segment_vma): New.
	Set vma and lma for a segment.
	(write_object_file) [BFD_ASSEMBLER && OBJ_COFF && TE_GO32]: Use it.

Index: src/gas/write.c
===================================================================
RCS file: /cvs/src/src/gas/write.c,v
retrieving revision 1.12
diff -c -p -r1.12 write.c
*** write.c	2000/04/03 12:05:31	1.12
--- write.c	2000/06/28 16:28:19
*************** static void remove_subsegs PARAMS ((frch
*** 133,138 ****
--- 133,142 ----
  static void relax_and_size_all_segments PARAMS ((void));
  #endif
  
+ #if defined (BFD_ASSEMBLER) && defined (OBJ_COFF) && defined (TE_GO32)
+ static void set_segment_vma PARAMS ((bfd *, asection *, PTR));
+ #endif
+ 
  /*
   *			fix_new()
   *
*************** set_symtab ()
*** 1348,1353 ****
--- 1352,1370 ----
  }
  #endif
  
+ #if defined (BFD_ASSEMBLER) && defined (OBJ_COFF) && defined (TE_GO32)
+ static void
+ set_segment_vma (abfd, sec, xxx)
+      bfd *abfd;
+      asection *sec;
+      PTR xxx ATTRIBUTE_UNUSED;
+ {
+   static bfd_vma addr = 0;
+   bfd_set_section_vma (abfd, sec, addr);
+   addr += bfd_section_size (abfd, sec);
+ }
+ #endif /* BFD_ASSEMBLER && OBJ_COFF && TE_GO32 */
+ 
  /* Finish the subsegments.  After every sub-segment, we fake an
     ".align ...".  This conforms to BSD4.2 brane-damage.  We then fake
     ".fill 0" because that is the kind of frag that requires least
*************** write_object_file ()
*** 1479,1484 ****
--- 1496,1509 ----
  #else
    relax_and_size_all_segments ();
  #endif /* BFD_ASSEMBLER */
+ 
+ #if defined (BFD_ASSEMBLER) && defined (OBJ_COFF) && defined (TE_GO32)
+   /* Now that the segments have their final sizes, run through the
+      sections and set their vma and lma. !BFD gas sets them, and BFD gas
+      should too. Currently, only DJGPP uses this code, but other
+      COFF targets may need to execute this too.  */
+   bfd_map_over_sections (stdoutput, set_segment_vma, (char *) 0);
+ #endif /* BFD_ASSEMBLER && OBJ_COFF && TE_GO32 */
  
  #ifndef BFD_ASSEMBLER
    /*




More information about the Binutils mailing list