This is the mail archive of the
mailing list for the SID project.
Re: thanks for the support.
- From: "T Satish Kumar" <satish at td dot idc dot lsi dot sanyo dot co dot jp>
- To: "Robert Cragie" <rcc at jennic dot com>, <sid at sources dot redhat dot com>,<ecos-discuss at sources dot redhat dot com>
- Date: Thu, 26 Sep 2002 09:01:39 -0700
- Subject: Re: thanks for the support.
- References: <NDBBLOIOMLKELOJBAPAGIEACCPAA.firstname.lastname@example.org>
yes, all this i did on cygwin environment..(Windows 2000).
well, thanks for the mini-HOWTO doc..this was definetly very useful..
but, most of the problems i faced was in building the ARM GNU tools..
well, one thing i noticed was sid installation required Tcl-Tk 8.3
and since previously i had installed insight5.2..the sid installation was
any problems..but later when i switched to insight 5.1..i couldn't install
sid, and hence i used the previous installed sid.this gave no problems..so
well, i could run the programs successfully both on ecos 1.3.1 as
my ARM GNU Tools are as follows:
sid (latest sep 2002 release)
----- Original Message -----
From: "Robert Cragie" <email@example.com>
To: "T Satish Kumar" <firstname.lastname@example.org>;
Sent: Wednesday, September 25, 2002 2:37 AM
Subject: RE: thanks for the support.
> I presume you did this under a cygwin environment, and I hope you found
> mini-HOWTO I wrote useful. It would be useful to know what changes to the
> procedure outlined in the mini-HOWTO are necessary to get it to work under
> cygwin, then everyone can benefit.
> Robert Cragie, Design Engineer
> Jennic Ltd, Furnival Street, Sheffield, S1 4QT, UK
> http://www.jennic.com Tel: +44 (0) 114 281 2655
> -----Original Message-----
> From: email@example.com [mailto:firstname.lastname@example.org]On
> Behalf Of T Satish Kumar
> Sent: 26 September 2002 01:44
> To: email@example.com; firstname.lastname@example.org
> Subject: Re: thanks for the support.
> well, works fine even with ecos v2.0 :-)
> ----- Original Message -----
> From: T Satish Kumar
> To: email@example.com ; firstname.lastname@example.org
> Sent: Wednesday, September 25, 2002 5:28 PM
> Subject: thanks for the support.
> Finally i am able to run the programs on the sid successfully.
> but using ecos 1.3.1
> thanks for your invaluable support.
> T Satish Kumar
> Design Engineer
> SANYO, JAPAN.